Sıcak kamaralı döküm makinesi - Dikey

FRECH DAW 80S

Clamping force: 900 kN
Clamping platen: 540 x 540 mm
Tie bar spacing: 350 x 350 mm
Machine weight: approx. 5.5 t
Clamping stroke: 280 mm
Ejector force: 60 kN
Ejector stroke: 70 mm
Mould height: 160–400 mm
Tie bar diameter: 65 mm
Casting force: 75 kN
Casting stroke: 130 mm
Casting piston diameter: 50, 55, 60 mm
Casting volume (DIN 24480): 119, 163, 214 cm³
Specific casting pressure: 380, 315, 265 kp/cm²
Corresponding parting area: 236, 285, 340 cm²
Retraction stroke: 150 mm
Completely overhauled DAW 80 GO die casting machine with DataLogic control system, suitable for processing zinc alloys.

Scope of overhaul includes:
• Upgrade with new control cabinet and new operator panel including replacement of all electrical wiring
• Renewal of hydraulics (blocks and valves)
• Overhaul of the clamping unit
Detailed information available upon request

The machine is equipped with the following options:
- Motor-driven safety door, casting direction left
Bedpjyzt D Eofx Agtewn
- Discharge chute cover on machine base (straight)
- Free-standing operator panel
1.0.2 Discharge chute cover on machine base
3.2.4 Multi-chamber holding and melting furnace with TOC pump
3.2.1 Furnace control cabinet for furnace type Z
4.0.1 Use of water-glycol
4.2. – Side GO
6.1.3.1 Wired signal interface for part removal (DISPO10)
6.5.2 Equipment package RSD with switch
7.2.2.2 Spraymotion 611 E with servo drive, single-circuit
7.3.1 Release agent container TD 20
7.4.0.3 Spray bar CR 275

Additional options can be offered upon request.

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.