Platform açık

Fliegl TPS 200 Jumbo Z

Further Information
Chassis Central Axle Trailer
Fine-grain steel welded construction
Type TPS 200 (special permit required)
Support leg at front with gearbox
Foldable rear support
Wheel chocks with brackets
Aluminum side underrun protection
Full-width rear mudflap
Mudflaps in front of each axle and anti-spray mudflaps behind each axle
1x spare wheel carrier for 1 spare wheel, with wheel mounting kit
1x spare wheel, same make as main tires, steel rim
1x stainless steel tool box, w=600/h=400/d=500 mm, with polished door, lockable
Tie-down eyes for low-bed trailer
5 pairs of stake pockets recessed in the outer frame, internal dimensions 70 x 40 mm (convertible to 5 t lashing rings, not included)
7 pairs of lashing mushrooms recessed on top and side of the outer frame, each rated 10 t
2 additional pairs of folding lashing rings recessed in low-bed area, each rated 10 t (1 pair at the front, 1 pair at rear bevel)
Drawbar Central Axle Trailer
Drawbar with certified 50 mm towing eye
Hnedpfx Aop N Dgued Rou
Axles + Suspension
SAF drum brake axles
Axles/chassis laser-aligned to reduce tire wear and fuel consumption
Axle spacing 1810 mm (10 t axle load technical)
Air suspension
Braking System
2-line compressed air brake system, colored routing for easy maintenance
Spring-loaded parking brake
Duomatic coupling at front with connection line to towing vehicle
EBS, Electronic Braking System, with EBS plug at front, with connection cable
Note: The trailer may only be towed by vehicles that ensure effective ABS function!
With lift & lower valve
Vehicle stability system
Axle load detection via EBS CANbus signal, for display in the truck cab (truck must be pre-equipped; no truck installation / not a calibrated scale)
Wheels and Tires
235/75 R17.5 brand Fulda
Steel rims, factory silver
Electrics
24 volt, multi-chamber lights, side yellow LED lighting
2 white front position lights
2 white/red marker lights rear
1 x 15-pin plug at the front, with connection cable
1 additional LED worklight at rear, switched via reverse gear
1x LED beacon with holder, switched via parking light (removable beacon)
Floor
70 mm softwood floor, steel/chequer plate covering in wheel arch area
Rear bevel with Mega Grip covering made of serrated grating
Low-bed area including rear bevel: 6500 mm
Front wall / front corner posts
25 mm aluminum hollow section, 400 mm high, removable
Access Ramps
Steel ramps, 3600 mm long, 750 mm wide, split with cable tensioning, laterally adjustable
Ramp shift: minimum gap approx. 600 mm, maximum outside width approx. 2880 mm
Ramp covering with Mega Grip from serrated grating
Operation hydraulically via independent electrohydraulic unit, installed in steel cabinet, operated from the right side in front of the rear fender. Note: Nato socket with connection cable on truck required. Cable must not be connected during travel!
Hydraulic side shift of loading ramps, individually controllable (only in combination with hydraulic ramp operation)
Operating Instructions
The total weight indicated is technically feasible; actual total weight may not be reached depending on the load, as permissible axle, drawbar, and kingpin loads must be observed (poor driving and tracking characteristics possible with improper load distribution).
For 10,000 kg axle load a special permit is required. The permit must be requested individually in each federal state. There is no guarantee of approval for 20 t GVW by law. Customer's risk.

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.