Alçak yükleyici

Fliegl ZTS 200 P

Further Information
Chassis Low-loader Trailer
Welded steel construction
Turntable with heavy-duty ball bearing slewing ring, tool box recessed in the turntable frame
Foldable rear support
Wheel chocks with holders
Aluminium side underrun protection
Half-shell mudguards on 1st axle, quarter-shell mudguards in front of and behind the 2nd axle
with anti-spray mudflaps behind each axle
1 plastic toolbox with shelf, w=620/h=360/d=440 mm, lockable with padlock (lock not included)
Extendable deck widenings to 3,000 mm (not in rear chamfer)
(the track width of the construction machines or vehicles to be transported must not exceed the outer frame width of 2,550 mm), central compartment for timber planks on the loading area, 70 mm planks for widening to 3,000 mm
Lashing Points Low-loader
3 pairs of 10 t lashing points integrated in the floor at the front
6 pairs of lashing mushrooms, 10 t each, recessed at the top and side in the outer frame
1 x after gooseneck, remaining distributed in between, spacing not greater than 1,200 mm
1 x rear chamfer
5 pairs of ring lashing eyes in the outer frame, 5 t each (instead of stake pockets)
Trailer Drawbar Assembly - Turntable trailer
Drawbar with tested 40 mm towing eye
Axles & Suspension
SAF drum brake axles
Axles/chassis laser measured to reduce tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushings
Wheels and Tyres
235 / 75 R 17.5
As per manufacturer's choice
Steel rims in twin arrangement, factory silver
Braking System
2-line compressed air braking system
Spring-loaded parking brake
2 interchange-proof coupling heads at the front, with connecting lines to the tractor unit
ABS and ALB, with ABS plug at the front, with connecting cable
Note: This trailer may only be towed by tractor units that ensure the effectiveness of the ABS!
Electrics
24 Volt, multi-chamber lights, yellow LED side markers
2 white/red lane marker lights at the rear
2 white position lights at the front
1 revolving beacon with holder, switchable via parking light (beacon removable)
2 pairs of warning signs, double LED illuminated, extendable to 3,000 mm
2 x 7-pin interchange-proof plugs at the front, with connecting cable
Deck
Front section with steel floor,
then 70 mm softwood floor, wheel arch areas with steel/chequer plate covering
Rear chamfer with 70 mm softwood floor
Gjdpfei Ri N Hex Ad Rskc
Low-loading area incl. rear chamfer 8,200 mm
Access Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Additional foldable ramp lock at the bottom (prevents side slippage of ramps, not in combination with hydraulic side ramp adjustment)
Wood covering
Assisted by spring lifters
Operating Notes
Special permit is required for 10,000 kg axle load. Permit must be applied for individually in each federal state; the legislator is not obliged to guarantee a permit for 20 t GVW. Customer's responsibility.
The specified total weight is technically possible, depending on the load, the permissible gross weight may not be achievable due to axle/support/saddle load restrictions.
Registration / Plates
Country of registration: Germany
Test approval according to EC 2007/46
24/7-Service Hotline
Prepared for two-line number plate holder
Contour marking with reflective strips according to ECE R 048, white on sides and red at rear
Warning sign according to ECE - 70
Paintwork
Frame: DB Novagrau
Ramps: hot-dip galvanised

Note: Archive photos!

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.