Ahşap işleme merkezi

Holzfraese HP 1890

Used machine

Year of manufacture: 2019

Only 110 operating hours!

Equipment and technical data:

Travel paths:
- X = 1800 mm
- Y = 900 mm
- Z = 80 mm

Made from 18 mm Koskisen panels

Milling bed made of 19 mm MDF as a sacrificial plate with guide rails and T-slot nuts, used as the clamping method.

Base frame with cross-bracing, filled with polymer concrete, prepared for transport by pallet truck or forklift.

Mechanical set consisting of profile linear guides incl. guide carriages, as well as ball screw drives 2010 and 1605 for all axes.

Shaft couplings and high-performance grease for lubricating the individual carriages, as well as cable drag chains incl. connection sets.

Control set consisting of a Triple Beast controller for driving 3 axes, with Ethernet connection.

Leadshine driver for the fourth motor. Four stepper motors, 5.0A, 3Nm with motor cables, power supply unit with 48 V, 6.7 A, LED board for breakout board, ribbon cables and proximity sensors, small parts such as single wire leads, ferrules, control cables, heat shrink tubing, and cable lugs. Fully installed in an aluminium enclosure incl. electrical kit and emergency stop.

- 21.5-inch monitor as built-in monitor, incl. mini PC with Windows 7, CAD software Rhino 5.0, G-code generator Estlcam, control software Beamicon2, as well as mouse and keyboard, pre-installed in an ergonomic console.

Tool length sensor for determining length and modification of the active zero offset.

Nedpfx Afszk Npge Aowi
Special features:

- High-frequency spindle with 2.2 kW, incl. clamping nut, frequency inverter, line filter, brake resistor, as well as collet set.

- PC with 8 GB RAM and AMD processor

- CAD software Rhino 5.0 for creating both simple 2D data and 3D solid models

Availability: short-term

Storage location: Flörsheim

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.