Broş makinesi

Rausch RS3/800

Manufacturer: Rausch (Haan/ Rhld)
Model: RS 3 G/800
Machine No.: 2968/424
Year of manufacture: 1970
Weight: 370 kg
Overhaul: 8/2025 by Wiemers AG
Our Ref. / Machine No.: WAG 787

General / Technical data:
Unused, overhauled mechanical vertical broaching machine by Rausch
Tensile force: 3,000 kg (30 kN)
Broaching speeds: 3 m/min and 6 m/min
Return speed: 3 m/min
Maximum stroke: 800 mm
Ijdpfxeytvyxe Adzeif
Maximum tool length: 1,000 mm
Table size / working area: 340 mm x 220 mm / 430 mm x 310 mm
Table opening: Ø 90 mm for standard broaching mandrels
Workpiece diameter: unlimited (without splash guard enclosure)
Dimensions (H x W x D): 1,950 mm x 820 mm x 900 mm (H = table height from floor without attachments)
Motor: 3.5 kW
Power supply: 400 Volt / 50 Hz

Accessories / Special Features:

- Modified drive system with geared motor and toothed belt drive
- 2 broaching speeds: 3 m/min & 6 m/min
- External stroke adjustment, cross-machine reproducible tool length setting system
- Integrated coolant system with check valve and drain tap, as well as selector switch for automatic operation (not automatically switching in pivot mode)
- Patented coolant/lubricant swivel system
- 3-sided enclosed, forward-opening splash guard (without external control panel)
- Machine cover below the safety door with chip protection and tool storage area
- Electrical wiring laid in steel protective conduits
- Electrical detection of clamping jaws (tool removal control to prevent unintentional retraction of the pull bridge)
- Safety door with integrated emergency stop function
- Control panel made of stainless steel sheet with permanent labelling
- 4 central lubrication points for the trapezoidal spindle drive
- Machine documentation

Note:

The machine has been completely overhauled; the machine body has been fully reconditioned. The following wear parts have been replaced:

- New trapezoidal spindles and spindle nuts made from cast wear-resistant bronze
- All bearings and seals have been renewed
- The central drive shaft is new
- The coolant system (pump, check valve, and drain tap), including the coolant/lubricant swivel system, is new
- The clamping jaws are new (pull bridge additionally reinforced)
- A switchable clamping jaw monitoring system has been installed (additional safety for operator & prevention of tool breakage)
- A safety door with monitoring system has replaced the rubber safety guard
- The tool length setting system has been relocated outside the machine enclosure
- Additional end position limit switches have been installed
- The entire electrical system (control cabinet) with Siemens components is new
- Control panel made of stainless steel with permanent labelling
- New SEW geared motor with toothed belt drive
- The machine has been newly painted with a 2-component structured paint

The machine is stored at our warehouse and can be inspected under power on site.

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.