WPM 400-C

WPM WPM 400-C

The machine is currently undergoing an overhaul.

PROCESSABLE MATERIALS
Depending on material properties and sheet design:
- Paper with a basis weight of at least 80 g/m²
- Cardboard or solid board up to a basis weight of 2,000 g/m² and corrugated board up to a total thickness of 4 mm (maximum sheet curvature 4%)

PERFORMANCE DATA
Maximum sheet format: 820 x 1,130 mm
Minimum sheet format: 350 x 400 mm
Maximum die-cutting force: (400 t) 4.0 MN
Maximum machine speed: 9,000 sheets/hour

Standard Equipment of the Machine:
Feeder
Non-stop high-performance sheet feeder W3, equipped with:
• Automatic non-stop device
• Automatic pallet changing device
• Suction head
• Double sheet detection
• Motorized stack side alignment
• Motorized suction head adjustment
• Belt table with pneumatic cover frame
• Compressed air and vacuum pump

Register Table
• Operator-side side lay, switchable between pull or push mode
• Photoelectric sensor for precise side edge alignment
• Fine adjustment of side lay
• Two active front lays, each with a photoelectric sensor for monitoring
• Two inactive front lays for sheet alignment stabilization
• Separate fine adjustment of the gripper edge for drive and operator sides
• LED display showing correct front and side register alignment
• Trend display for sheet arrival
• Misfeed rejection only disables the feeder
• Height-adjustable rear lay for secure sheet guidance
Kedeyuuzdopfx Aklena

Die-Cutting Station
• Roller-guided support rails for the locking frame
• Roller guidance for the cutting plate on swiveling support arms
• Motorized adjustment of die-cutting pressure
• Automatic device for lifting the locking frame to the platen
• Electronic die-cutting force display with maximum pressure limitation
• Under-table vacuum system for thin cutting plates

Stripping Section
• Frame drive and lift for the upper tool frame
• Sheet receiving system for the stripping board with Centerline fine adjustment
• Sample sheet removal device
• Upper stripping tool frame
• Lower stripping tool frame

Delivery Section
• Fully automatic pile delivery system, preselectable
• Partial stacks can be formed by automatically inserting uncut sheets (interleaves min. 250 g/m², max. 800 g/m²)
• Frame lift for upper tool frame
• Receiving device for change-over frames with motorized adjustment in running direction
• Pneumatic frame locking
• Selectable gripper opener cam and sheet ejector
• Sheet alignment device
• Integrated conveyor belt for removal of gripper edge waste or trim grids (double cut)
• Separator sheet magazine with electronic level monitoring, refillable from operator side during operation
• Tool frame with Centerline system
• Change-over frames for standard delivery/gripper edge removal
• Change-over frames for waste separation grid
• Mounting kit for separator punch
• 8 x sheet hold-down devices for standard delivery
• 4 x crosswise support bars

Options:
• QTM – Patented guide rails
• QTM – Locking frame with quick lock system and X/Y adjustment
• QTM – Upper stripping frame with quick lock system
• QTM – Upper delivery frame with quick lock system
• Conversion to latest Siemens S7 control system
• New generation frequency converters
• Modem for remote service connection
• Machine height increase to 900 mm

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.