Kereste taşıyıcı

Fliegl SDS 380 Holzrungenaufbau

Further Information
Chassis for Semitrailer, Freight Forwarder Specification
Reinforced steel welded construction, only 2 longitudinal beams as double-T profiles with steel/chequer plate in between the beams, fifth wheel plate with replaceable 2'' kingpin. Protective cover for tail lights.
1 steel toolbox recessed between the longitudinal beams
8 pairs of lashing rings, bolted or welded to the frame as per manufacturer's choice
24 t 2-speed landing gear, single-sided operation, with straight base, without sliding compensation
2 wheel chocks with holders
Aluminum side underrun protection
Galvanized steel rear underrun protection
Half shell mudguards
With anti-spray flaps compliant with EU regulations
1 spare wheel holder for 1 spare wheel, including wheel fastening kit
8 timber post cradles as per manufacturer's specification, bolted to the frame, each with 2 telescopic wooden stakes extendable from 1,800 to 2,800 mm, 7 t per pair.
Axles & Suspension
SAF disc brake axles with 430 mm disc diameter
Air suspension with raise & lower valve, safety cable on axles
1st axle automatic lift axle, including forced lowering and start assist, operated via 3x braking (start assist functions up to 30% axle load exceedance and up to a max speed of 25 km/h)
Axle spacing offset (Combined Transport) up to 44 t gross combination weight
Wheels and Tyres
Fedpfx Aei Rivwod Rjpn
385 / 65 R 22.5
Manufacturer’s choice
Steel rims, factory silver
Braking System
Dual-line air pressure brake system
Spring-loaded parking brake
Axle load detection via EBS-Canbus signal, for display in the driver’s cab; truck must be pre-equipped accordingly, not installed on truck (not an approved scale)
2 fail-safe coupling heads at the front, without connecting line
EBS electronic braking system with EBS socket at the front, without connector cable
Attention: This trailer may only be towed by tractors that guarantee correct ABS performance!
Electrics
24 Volt, multi-chamber lights, side yellow LED lighting
2 white position lights at front
2 white/red lane marker lights at rear
2 x 7-pin and 1 x 15-pin fail-safe sockets at front, without connector cable
Front Bulkhead/Corner Posts
Steel/mesh front bulkhead, approx. 2,300 mm high, bolted to the frame
Approval / Plates
Country of Registration: Germany
Approval as per EC 2007/46
Prepared for single-line number plate holder
Contour marking with reflective tape as per ECE R 048, white on sides and red at rear
Paintwork
Frame DB 7350 Novagrau
Landing legs coated black
Bulkhead hot-dip galvanized
Note: Archive images!

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.